Xylem CPC Multi Drive Setup Manuel d'utilisateur télécharger pdf

Steps for setting up 2 (or more) communicating Aquavar CPC drives:

Connect 3 Wires

to terminals 29,

30 & 31 on both

drives

On the Keypad of the first

drive Go To:

Parameters

Group 11

Parameter 1102

(Application macro)

Change to: Multicontrol

Now on the 2

Drive,

Exit out to Groups

Go to Group 22

Parameter 2207

(Pump Address)

Change value to 2

Repeat step 2 on the 2nd drive

Repeat steps 3 and 4 for (up to 2) additional

drives as needed

These simple instructions are in addition to the

basic wiring and programming used for setting

up individual drives.

For expanded detail of Aquavar CPC setup and

capabilities, refer to IM167, Aquavar CPC Instruction

and Operation manual.

(Recommend 22AWG 3 or 4 wire shielded cable)

Notes:

February 2011

Steps for setting up 2 (or more) communicating Aquavar CPC drives: 1 Connect 3 Wires to terminals 29, 30 & 31 on both drives 2 On the Keypad of th

Pas de commentaire

Xylem CPC Multi Drive Setup Manuel d'utilisateur